You can translate the output of the slice filter in the Z direction (or any
other direction) using the Transform filter.
-Ken
On 11/28/08 8:20 AM, "Stephen Wornom" <[EMAIL PROTECTED]> wrote:
I have to parallel planes offset by a constant z. I slice twice to get
the two planes, z1 and z2 (z2= z1+ conste).
I would like to overlay the wire frames (remove the z-offset from plane
z2), how does one do this?
Stephen
--
[EMAIL PROTECTED]
2004 route des lucioles - BP93
Sophia Antipolis
06902 CEDEX
Tel: 04 92 38 50 54
Fax: 04 97 15 53 51
**** Kenneth Moreland
*** Sandia National Laboratories
***********
*** *** *** email: [EMAIL PROTECTED]
** *** ** phone: (505) 844-8919
*** web: http://www.cs.unm.edu/~kmorel
_______________________________________________
ParaView mailing list
[email protected]
http://www.paraview.org/mailman/listinfo/paraview
