>Unfortunately, I get something different:
> clipper.GetProperty('ClipType')
><paraview.servermanager.Plane object at 0x6e839b0
You need to append .Available to the end of the command, so:
clipper.GetProperty('ClipType').Available
Hope it helps.
===================================
Adriano Gagliardi MEng PhD
Project Scientist
Computational Aerodynamics
Aircraft Research Association Ltd.
Manton Lane
Bedford
Tel: 01234 32 4644
E-mail: [email protected]
Url: www.ara.co.uk
-----Original Message-----
From: Jeshua Lacock [mailto:[email protected]]
Sent: 13 August 2009 10:12
To: [email protected]
Cc: [email protected]
Subject: Re: [Paraview] ClipFunction Property
On Aug 13, 2009, at 2:55 AM, Jeshua Lacock wrote:
>> //set the clip type to plane
>> clipper.ClipType = Plane
>
> When I try that I get:
>
> >>> clipper.ClipType = Plane
I figured it out - I just need to add quotes:
>>> clipper.ClipType = "Plane"
It is working great now, thank you very much for your help Adriano!
Best,
Jeshua Lacock
Founder/Programmer
3DTOPO Incorporated
<http://3DTOPO.com>
Phone: 208.462.4171
---------------------------
This email contains information that is private and confidential and is
intended only for the addressee. If you are not the intended recipient please
delete it and notify us immediately by e-mailing the sender.
Note: All email sent to or from this address may be accessed by someone other
than the recipient, for system management and security reasons.
Aircraft Research Association Ltd. Registered in England, Registration No
503668 Registered Office: Manton Lane, Bedford MK41 7PF England VAT No GB
196351245
_______________________________________________
Powered by www.kitware.com
Visit other Kitware open-source projects at
http://www.kitware.com/opensource/opensource.html
Please keep messages on-topic and check the ParaView Wiki at:
http://paraview.org/Wiki/ParaView
Follow this link to subscribe/unsubscribe:
http://www.paraview.org/mailman/listinfo/paraview
