What version of Qt are you using? Ensure that QT_HELP_GENERATOR is set to the qhelpgenerator executable.
Utkarsh On Thu, Jan 7, 2010 at 7:44 AM, Robert Sawko <r.sa...@cranfield.ac.uk> wrote: > Dear All, > > I am trying to run compile ParaView on 64 bit openSUSE 11.2 with KDE > 4.3.1. I was using this website as a reference > http://www.cmake.org/Wiki/ParaView:Build_And_Install. Unfortunately > after configuring the installation with ccmake I get > QT_HELP_GENERATOR-NOTFOUND in QT_HELP_GENERATOR variable. Executing > make ends up with an error: > > [ 99%] Built target H5PartReader > [ 99%] Compiling Qt help project paraview.qhp > /bin/sh: QT_HELP_GENERATOR-NOTFOUND: command not found > make[2]: *** [Documentation/CMakeFiles/ParaViewOnlineHelp] Error 127 > make[1]: *** [Documentation/CMakeFiles/ParaViewOnlineHelp.dir/all] Error 2 > > Could you let me know if you had any hints as to solve this problem? I > would be very much obliged for any assistance. > > Kind regards, > Robert > _______________________________________________ > Powered by www.kitware.com > > Visit other Kitware open-source projects at > http://www.kitware.com/opensource/opensource.html > > Please keep messages on-topic and check the ParaView Wiki at: > http://paraview.org/Wiki/ParaView > > Follow this link to subscribe/unsubscribe: > http://www.paraview.org/mailman/listinfo/paraview > _______________________________________________ Powered by www.kitware.com Visit other Kitware open-source projects at http://www.kitware.com/opensource/opensource.html Please keep messages on-topic and check the ParaView Wiki at: http://paraview.org/Wiki/ParaView Follow this link to subscribe/unsubscribe: http://www.paraview.org/mailman/listinfo/paraview