Dear All, I've been trying to read in a Tecplot ASCII file containing data of type FELINESEG, but the ParaView reader doesn't seem to recognise it. It reads fine into Tecplot itself. The header I'm using is:
TITLE = "temp" VARIABLES = "X", "Y", "Z" "cp" ZONE T="CUT1", DATAPACKING=POINT, NODES=2, ELEMENTS=1, ZONETYPE=FELINESEG 0.0 0.0 0.0 0.5 1.0 0.0 0.0 1.0 1 2 This is an example, but it should read in fine. The Tecplot reader I'm using is from a November/December CVS snapshot, so I could be using an out-of-date version. It would be useful if someone could confirm whether this problem still exists in newer releases. Thanks in advance. Cheers, Adriano =================================== Adriano Gagliardi MEng PhD Project Scientist Computational Aerodynamics Aircraft Research Association Ltd. Manton Lane Bedford Tel: 01234 32 4644 E-mail: [email protected] Url: www.ara.co.uk --------------------------- This email contains information that is private and confidential and is intended only for the addressee. If you are not the intended recipient please delete it and notify us immediately by e-mailing the sender. Note: All email sent to or from this address may be accessed by someone other than the recipient, for system management and security reasons. Aircraft Research Association Ltd. Registered in England, Registration No 503668 Registered Office: Manton Lane, Bedford MK41 7PF England VAT No GB 196351245 _______________________________________________ Powered by www.kitware.com Visit other Kitware open-source projects at http://www.kitware.com/opensource/opensource.html Please keep messages on-topic and check the ParaView Wiki at: http://paraview.org/Wiki/ParaView Follow this link to subscribe/unsubscribe: http://www.paraview.org/mailman/listinfo/paraview
