Yes, that's as expected, at least in 3.14. Support for that was added later, if I remember correctly.
On Mon, May 6, 2013 at 8:39 AM, Stephen Wornom <[email protected]> wrote: > After load the PV file (.pvtu) > 1-I turn on trace > do slice, clip, then contour > save data > 2-I turn off trace > save the trace.py file > When I edit the trace.py file everything is there EXCEPT the save data > command. > Is this normal? > Thanks in advance, > Stephen > > -- > [email protected] > 2004 route des lucioles - BP93 > Sophia Antipolis > 06902 CEDEX > > Tel: 04 92 38 50 54 > Fax: 04 97 15 53 51 > > > _______________________________________________ > Powered by www.kitware.com > > Visit other Kitware open-source projects at > http://www.kitware.com/opensource/opensource.html > > Please keep messages on-topic and check the ParaView Wiki at: > http://paraview.org/Wiki/ParaView > > Follow this link to subscribe/unsubscribe: > http://www.paraview.org/mailman/listinfo/paraview > _______________________________________________ Powered by www.kitware.com Visit other Kitware open-source projects at http://www.kitware.com/opensource/opensource.html Please keep messages on-topic and check the ParaView Wiki at: http://paraview.org/Wiki/ParaView Follow this link to subscribe/unsubscribe: http://www.paraview.org/mailman/listinfo/paraview
