The wireframe shows the edges of the mesh so... use a higher resolution mesh. There might be other tricks you could use, like apply a texture to a surface, but that depends on the nature of your data.
Maybe it would help if it was more clear what you are trying to do. I don't know what you mean by offset lines or really see anything in your image you would want to remove. If you added more lines they would just follow the existing lines until it became too dense to see any of them. -Ken Sent from my iPad so blame autocorrect. On Sep 23, 2013, at 5:50 PM, "Colin McAuliffe" <[email protected]> wrote: > Hi all, > > I am using paraview to generate figures of a distorted mesh. I am using a > wireframe representation. Are there options available to improve the > resolution of the wireframe representation to eliminate the offset lines as > shown in the attached figure? > > Thanks and all the best, > Colin > > > > > -- > Colin McAuliffe > PhD Candidate > Columbia University > Department of Civil Engineering and Engineering Mechanics > <MESHE08M28.png> > _______________________________________________ > Powered by www.kitware.com > > Visit other Kitware open-source projects at > http://www.kitware.com/opensource/opensource.html > > Please keep messages on-topic and check the ParaView Wiki at: > http://paraview.org/Wiki/ParaView > > Follow this link to subscribe/unsubscribe: > http://www.paraview.org/mailman/listinfo/paraview _______________________________________________ Powered by www.kitware.com Visit other Kitware open-source projects at http://www.kitware.com/opensource/opensource.html Please keep messages on-topic and check the ParaView Wiki at: http://paraview.org/Wiki/ParaView Follow this link to subscribe/unsubscribe: http://www.paraview.org/mailman/listinfo/paraview
