Hi Ken, It looks like the file was too large to be broadcast to the list, but I think it should have gone to you directly.
Thanks again for your help, Paul On 8 November 2013 08:35, Paul Graham <[email protected]> wrote: > Hi Ken, > > I have attached a sample of the data to this message along with the saved > Paraview state. Hopefully this will help diagnose why it is not working. > > Thanks again for your help. > > Paul > > > > On 8 November 2013 02:46, Moreland, Kenneth <[email protected]> wrote: > >> Would it be possible to send a small example of your data to the list >> so we could try it out? If not, could you at least send a screen shot so we >> could have a look at the mesh? Right now I'm just making blind guesses. >> >> -Ken >> >> >> From: Paul Graham <[email protected]> >> Date: Thursday, November 7, 2013 1:26 AM >> To: Kenneth Moreland <[email protected]> >> Cc: "[email protected]" <[email protected]> >> Subject: [EXTERNAL] Re: [Paraview] Stream Tracer Problem >> >> Hi Ken, >> >> Thanks for your suggestions. I still haven't worked out why it's not >> working, but I notice that no data is registering in the Stream Tracer >> filter. It's mesh is empty - no points or cells - and the bounding >> information not available. >> >> I tried a high density Line Source, as you suggested, as well as >> increasing the number of seed points within the radial ball of the Point >> Source but without success. However, both the Line Source and the Point >> Source correctly display within the domain of the 3D vector field. >> >> The vectors themselves (from the glyph filter) display correctly. >> >> Paul >> >> >> On 7 November 2013 09:05, Moreland, Kenneth <[email protected]> wrote: >> >>> That is not a lot of detail to go on so I have to guess what the >>> problem is. It is probably either that the seeds are not intersecting the >>> mesh or that vectors do not yield good lines. >>> >>> If you mesh is very thin or comprises surface elements, then chances >>> are all the seed points are outside your mesh. The default point source is >>> actually a point cloud with randomly selected points within a sphere of a >>> certain radius. If your mesh is flat, the chance of any seed happening to >>> hit it are extremely low. Try changing to a line source and see if that >>> helps. >>> >>> It could be that the vectors your creating are not integrating well. >>> It could be that the vectors are pointing off of the mesh (which is also >>> common in thin or flat meshes). Thus it dies before it starts. Or perhaps >>> it has some other feature that makes it difficult to integrate. >>> >>> -Ken >>> >>> From: Paul Graham <[email protected]> >>> Date: Wednesday, November 6, 2013 2:40 PM >>> To: "[email protected]" <[email protected]> >>> Subject: [EXTERNAL] [Paraview] Stream Tracer Problem >>> >>> Hi Everyone, >>> >>> I am unable to display a Stream Tracer and not sure what is going >>> wrong. After creating a vector field using the Calculator Filter, I added >>> the Stream Tracer filter using a point source seed (default setting). The >>> point source origin is displayed but nothing else. Can anyone help me as >>> to what I have to do to get the stream lines to show? >>> >>> Thanks in advance, >>> >>> Paul >>> >>>
_______________________________________________ Powered by www.kitware.com Visit other Kitware open-source projects at http://www.kitware.com/opensource/opensource.html Please keep messages on-topic and check the ParaView Wiki at: http://paraview.org/Wiki/ParaView Follow this link to subscribe/unsubscribe: http://www.paraview.org/mailman/listinfo/paraview
