Yep. That's what I was missing. Thanks!
Dalon
P.S. How embarrassing. I spelled my own name wrong.
On 06/12/2014 12:31 PM, Insley, Joseph A. wrote:
Daon,
In the vti format, the Whole Extent and Piece Extent are integers, and refer to
indices of the cells in each dimension, while Spacing refers to the spacing
between each cell. Looking at your vti file, your extents are 0 to 1, which
results in one cell, which goes from 0.0 to 0.125. If your intent is to have
multiple cells, which have a total bounds of 0.0 to 1.0, with a spacing of
0.125 between cells, change your extents to be 0 8, rather than 0 1.
Hope that helps,
joe
<?xml version="1.0"?>
<VTKFile type="ImageData" version="0.1" byte_order="LittleEndian">
<ImageData WholeExtent="0 1 0 1 0 1" Origin="0 0 0" Spacing="0.125 0.125 0.125">
<Piece Extent="0 1 0 1 0 1">
</Piece>
</ImageData>
</VTKFile>
On Jun 12, 2014, at 1:08 PM, oz wrote:
Hi,
I am attempting to write a structured mesh, which I've attached. When I open it
in paraview, only the first cell is displayed. When I look in the information
panel, the extent is correct, but the bounds only shows the bounds of the first
cell, and only the first cell is displayed. This happens for ImageData,
RectilinearGrids, and StructuredGrid. I am really at a loss as to what is going
on. I am using Paraview 4.1.0. Any help will be greatly appreciated.
Daon
<snapshot1.png><output11.vti>_______________________________________________
Powered by www.kitware.com
Visit other Kitware open-source projects at
http://www.kitware.com/opensource/opensource.html
Please keep messages on-topic and check the ParaView Wiki at:
http://paraview.org/Wiki/ParaView
Follow this link to subscribe/unsubscribe:
http://www.paraview.org/mailman/listinfo/paraview
_______________________________________________
Powered by www.kitware.com
Visit other Kitware open-source projects at
http://www.kitware.com/opensource/opensource.html
Please keep messages on-topic and check the ParaView Wiki at:
http://paraview.org/Wiki/ParaView
Follow this link to subscribe/unsubscribe:
http://www.paraview.org/mailman/listinfo/paraview
