Anton, Maybe try adding
stc->getProxy()->UpdateVTKObjects(); after setting the scalar range? It's always possible there is a bug in the rescaling logic. Do you have a minimal code example you could post to make it easier to track down? Thanks, Cory On Thu, Nov 20, 2014 at 10:47 AM, <[email protected]> wrote: > Hi, > > I am currently working on a visulalizer which makes use of ParaView. I am > running into an issue when manipulating the lookup table for a newly added > source. > > Here is my issue in detail: > > First I load a source. I then set the lookup table to have a specific range. > I get the representation repr and do the following: > > pqScalarsToColors* stc = repr->getLookUpTable(); > stc->setScalarRange(min, max); > repr->getProxy()->UpdateVTKObjects(); > repr->renderViewEventually(); > > I have min set to a value which is smaller than the lowest entry of the data > set and max is set to a value which is also smaller than the highest entry > of the data set. > > Looking at the displayed scalar range, it seems that the lookup table is set > to my min value and to the highest entry of the data set instead of my max > value. > > When I do the same thing with max being set higher than the largest value of > the data set, I don't get this issue. > > What am I missing? > > Thanks > > Anton > > This message is commercial in confidence and may be privileged. It is > intended for the > addressee(s) only. Access to this message by anyone else is unauthorized and > strictly prohibited. > If you have received this message in error, please inform the sender > immediately. Please note that > messages sent or received by the Tessella e-mail system may be monitored and > stored in an > information retrieval system. > > > > > _______________________________________________ > Powered by www.kitware.com > > Visit other Kitware open-source projects at > http://www.kitware.com/opensource/opensource.html > > Please keep messages on-topic and check the ParaView Wiki at: > http://paraview.org/Wiki/ParaView > > Follow this link to subscribe/unsubscribe: > http://public.kitware.com/mailman/listinfo/paraview > _______________________________________________ Powered by www.kitware.com Visit other Kitware open-source projects at http://www.kitware.com/opensource/opensource.html Please keep messages on-topic and check the ParaView Wiki at: http://paraview.org/Wiki/ParaView Follow this link to subscribe/unsubscribe: http://public.kitware.com/mailman/listinfo/paraview
