---
doc/C/parted.8 | 27 ++++++++++++---------------
1 file changed, 12 insertions(+), 15 deletions(-)
diff --git a/doc/C/parted.8 b/doc/C/parted.8
index 171269c..c852112 100644
--- a/doc/C/parted.8
+++ b/doc/C/parted.8
@@ -54,7 +54,6 @@ Use optimum alignment as given by the disk topology
information. This
aligns to a multiple of the physical block size in a way that guarantees
optimal performance.
.RE
-
.SH COMMANDS
.TP
.B [device]
@@ -62,8 +61,7 @@ The block device to be used. When none is given,
\fBparted\fP will use the
first block device it finds.
.TP
.B [command [options]]
-Specifies the command to be executed. If no command is given,
-.BR parted
+Specifies the command to be executed. If no command is given, \fBparted\fP
will present a command prompt. Possible commands are:
.RS
.TP
@@ -119,8 +117,8 @@ or an LVM logical volume if necessary.
.B set \fIpartition\fP \fIflag\fP \fIstate\fP
Change the state of the \fIflag\fP on \fIpartition\fP to \fIstate\fP.
Supported flags are: "boot", "root", "swap", "hidden", "raid", "lvm", "lba",
-"legacy_boot", "irst", "msftres", "esp", "chromeos_kernel", "bls_boot",
"linux-home",
-"no_automount", "bios_grub", and "palo".
+"legacy_boot", "irst", "msftres", "esp", "chromeos_kernel", "bls_boot",
+"linux-home", "no_automount", "bios_grub", and "palo".
\fIstate\fP should be either "on" or "off".
.TP
.B unit \fIunit\fP
@@ -140,10 +138,10 @@ On MS-DOS set the type aka. partition id of
\fIpartition\fP to
the type-uuid of \fIpartition\fP to \fIuuid\fP.
.TP
.B disk_set \fIflag\fP \fIstate\fP
-Change a \fIflag\fP on the disk to \fIstate\fP. A flag can be either "on" or
"off".
-Some or all of these flags will be available, depending on what disk label you
-are using. Supported flags are: "pmbr_boot" on GPT to enable the boot flag on
the
-GPT's protective MBR partition.
+Change a \fIflag\fP on the disk to \fIstate\fP. A flag can be either "on" or
+"off". Some or all of these flags will be available, depending on what disk
+abel you are using. Supported flags are: "pmbr_boot" on GPT to enable the
+boot flag on the GPT's protective MBR partition.
.TP
.B disk_toggle \fIflag\fP
Toggle the state of the disk \fIflag\fP.
@@ -155,24 +153,23 @@ Display version information and a copyright message.
\fBparted\fP will compute sensible ranges for the locations you specify when
using
units like "GB", "MB", etc. Use the sector unit "s" or IEC binary units like
"GiB", "MiB", to specify exact locations.
-
When you specify start or end values using IEC binary units like "MiB",
"GiB", "TiB", etc., \fBparted\fP treats those values as exact, and equivalent
to
the same number specified in bytes (i.e., with the "B" suffix), in that it
provides no helpful range of sloppiness. Contrast that with a partition
start request of "4GB", which may actually resolve to some sector up to 500MB
-before or after that point. Thus, when creating a partition in an exact
location
-you should use units of bytes ("B"), sectors ("s"), or IEC binary units like
-"MiB", "GiB", but not "MB", "GB", etc.
+before or after that point. Thus, when creating a partition in an exact
+location you should use units of bytes ("B"), sectors ("s"), or IEC binary
units
+like "MiB", "GiB", but not "MB", "GB", etc.
.SH REPORTING BUGS
Report bugs to <[email protected]>
.SH SEE ALSO
.BR fdisk (8),
.BR mkfs (8),
The \fIparted\fP program is fully documented in the
-.BR info(1)
+.BR info (1)
format
-.IR "GNU partitioning software"
+.I "GNU partitioning software"
manual.
.SH AUTHOR
This manual page was written by Timshel Knoll <[email protected]>,
--
2.49.0
