HI I have been useing the real tech sound card with g w for years. works fine. Go to your controll panel, enter on sounds and audio devices, then go to the voice tab on the top, then tab too voice recording volume button enter, and turn down the sliders regards Don.
----- Original Message ----- From: "Darran Ross" <[EMAIL PROTECTED]> To: <[email protected]> Sent: Friday, January 19, 2007 3:19 PM Subject: Goldwave, Realtec AC97 and the Audigy NX 2 > Hello to all from a new list member. > > I've joined this list specifically to get help with a recording problem > I'm > having at the moment. Its probably easier if I just lay it all out for you > here and see how we get on! > > I wanted to record some films etc from my hard drive recorder onto the PC > and I installed Goldwave 5.1 to help me achieve this. > > However, even after reading manuals and getting help from other sources, > each and every attempt to record something failed miserably. The playback > always sounded as though my levels were far to high, leaving me with a > heavily distorted recording. I tried every possible combination of > settings > and levels, but each and every attempt resulted in the same distortion. > > I started asking around to see if anyone could help, and the general > feeling > was that the Realtec AC97 Audio I was using as part of my PC set-up may > have > been the weak link. So, taking more advice on board, I've now bought > myself > an external soundcard, the Creative Audigy NX2, in the hope that this will > make things right. The NX 2 arrived today, and I now find myself with more > questions than answers! It'll be Sunday before I can get hold of sighted > assistance and then I remembered about PC-Audio! > > So, my first question is, is it possible to run the NX2 and the Realtec > AC97 > side-by-side? Or do I need to disable the AC97 while using the NX2 and > vice > versa. > > Ideally, I'm hoping the NX2 will work with Goldwave 5.1 and enable me to > make my recordings.But I've noticed that after connecting it up tonight I > lost my existing PC audio. Everything went silent, no JAWS no nothing, > until > I disconnected the NX2 again. > > What I'm really hoping to find on this list is someone who's already > successfully using Goldwave 5.1 with an external Audigy soundcard to make > recordings through the line-in facility on the card. This way I can obtain > some exact settings etc to help me get started with this whole PC audio > recording thing! > > Sorry if I haven't made myself at all clear about what I'm trying to do > here, and the problems I've run into whilst trying to do it, but if anyone > can offer any kind of help and advice, that would be very much > appreciated. > > Regards. > > Darran > > > > Audio List Help, Guidelines, Archives and more... http://www.pc-audio.org To unsubscribe from this list, send a blank email to: [EMAIL PROTECTED]
