to fade in set your end marker at the point of the piece where you want
full volume to be reached.
press alt c for effects
u for volume
i for fade in
arrow to one of the choices and press f4 to see how it sounds.
when you get the one you want press enter
Do the opposite at the end of the piece using the start marker and o for
fade out
----- Original Message -----
From: "Christopher Wright" <[email protected]>
To: "PC Audio Discussion List" <[email protected]>
Sent: Saturday, September 05, 2009 8:56 AM
Subject: Re: Faders in Goldwave.
Hi,
If you look through the menus, you should see a fade in command and a fade
out command. They might be in a submenu.
In Goldwave 4, which is what I have, I go to the Effects menu, down arrow
into it, up arrow to the volume submenu, right arrow into that,then look
for
either the fade in or fade out command.
----- Original Message -----
From: "Vinny Samarco" <[email protected]>
To: "PC Audio Discussion List" <[email protected]>
Sent: Saturday, September 05, 2009 10:30 AM
Subject: Faders in Goldwave.
Hi,
I have to do some editing of of music recordings using goldwave and need
to
be able to fade music in and out.
I have looked at the manual but can't understand where these controls
are,
and how to use them.
Any help would be greatly appreciated.
Vinny
To unsubscribe from this list, send a blank email to:
[email protected]
To unsubscribe from this list, send a blank email to:
[email protected]
__________ Information from ESET NOD32 Antivirus, version of virus
signature database 4398 (20090905) __________
The message was checked by ESET NOD32 Antivirus.
http://www.eset.com
To unsubscribe from this list, send a blank email to:
[email protected]
