two questions or three.
first question the boom arm it attaches to my desk via a clip right? if this
is the way it attaches, won't the humming from the fan under the desk still
come through because of the boom arm is attached?
second question, can I get any boom arm or one that is made for the blue
yeti pro. third and last question, sorry if this sounds dumb, will I have to
take the yeti off the desk stand or can I attach it to the boom arm as is.
thanks so much again.
----- Original Message -----
From: "tim cumings" <[email protected]>
To: "PC Audio Discussion List" <[email protected]>
Sent: Friday, February 14, 2014 3:47 PM
Subject: Re: need helping with humming on blue yeti pro.
you can get a boom arm for $50.
----- Original Message -----
From: "angel.adorno1" <[email protected]>
To: "PC Audio Discussion List" <[email protected]>
Sent: Friday, February 14, 2014 6:33 AM
Subject: Re: need helping with humming on blue yeti pro.
I bought a mount, but I am returning it, I thought the shock mount I would
be able to use on top of my desk but I need a boom arm and I am not going
to spend the money for one do not need it that bad yet.
----- Original Message -----
From: "Dane Trethowan" <[email protected]>
To: "PC Audio Discussion List" <[email protected]>
Sent: Friday, February 14, 2014 2:58 AM
Subject: Re: need helping with humming on blue yeti pro.
Speaking of Yeti Pro, I've been meaning to get one for ages so did a
Google search to see where they're available in Australia and - believe
it or not - they're available right from the Apple Store which means
express free shipping etc so an order has been placed <smile>.
On 14 Feb 2014, at 6:28 pm, Ray <[email protected]> wrote:
You're getting some good tips on this and I found the link to Mic
technique good.
Whatever mic you are using you will get this problem if its sitting
directly above
the computer. I've moved my Rode mic over to another purch to the side
of the
desk, and though its not very convenient it cuts down the hum and
vibration quite a
bit.
I speak pretty close to the mic without encouraging pops. Sometimes I
use a bit of
base roll-off in the audio editor.
One more thing which can help is a mic shock mount, which should
isolate the mic
from stand-borne noise.
Hope some of that helps.
Ray.
**********
Dane Trethowan
Skype: grtdane12
Phone US (213) 438-9741
Phone U.K. 01245 79 0598
Phone Australia (03) 9005 8589
Mobile: +61400494862
Fax +61397437954
