>>do I need to use a LVD terminator plug even though the LVD will be used in SE (single ended) mode?<<
%Looks like a LVD terminator is needed-EricB% >From the Install guide: <http://www-3.ibm.com/storage/hdd/tech/techlib.nsf/techdocs/85256AB8006A 31E587256A96004C9804/$file/dnes_diweb11.pdf> *Drive Termination The SCSI bus must be terminated at both ends of the bus. If you have a single-ended Ultrastar 18ES, active termination is supplied on the jumper block. Ultra2 SCSI (LVD) models do not have onboard active termination. You will need to supply an external Ultra2 compatible terminator. %Also% *Disable Unit Attention Pin Available on all models. When a jumper is installed, the drive will not be able to send Unit Attention Sense information for commands immediately following a Power On Reset or SCSI Bus Reset. *Enable Auto Spin Up Available on 50 and 68 pin models. When a jumper is installed, the drive will spin up automatically after a power on reset. If a jumper is not installed, the drive will not spin up unless a Start Unit command is received. *Enable TI-SDTR/WDTR Available on 68/80 pin models. When a jumper is installed, Target Initiated Wide Data Transfer Request Negotiation and Target Initiated Synchronous Data Transfer Request Negotiation are enabled. %HTH% -- PCI-PowerMacs is sponsored by <http://lowendmac.com/> and... Small Dog Electronics http://www.smalldog.com | Refurbished Drives | -- Sonnet & PowerLogix Upgrades - start at $169 | & CDRWs on Sale! | Support Low End Mac <http://lowendmac.com/lists/support.html> PCI-PowerMacs list info: <http://lowendmac.com/lists/pci-powermacs.shtml> --> AOL users, remove "mailto:"; Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> Archive:<http://www.mail-archive.com/pci-powermacs%40mail.maclaunch.com/> Using a Mac? Free email & more at Applelinks! http://www.applelinks.com
