Hard Drive termination is usually a configuration of pins with itsy terminator caps, specific to the manufacturer. I would try to find the documentation for that drive where you will find a diagram for the proper configuration for the desired SCSI ID. Tom
< It's been a long time since I had to check the termination on an internal SCSI chain, and I am no longer sure how to do it. My belief is that the 4 gig drive that I boot from is set to ID 0, and that it the one that provides termination. That drive is physically mounted in a drive bay above the power supply. The new 18 gig drive is mounted in the lower front drive bay ID 2. An additional 4 gig drive is located in the drive bay above it, ID 1, just below the CD-ROM drive, ID 3. Any clues on how I can check the termination? Warren > -- PCI-PowerMacs is sponsored by <http://lowendmac.com/> and... Small Dog Electronics http://www.smalldog.com | Refurbished Drives | -- Sonnet & PowerLogix Upgrades - start at $169 | & CDRWs on Sale! | Support Low End Mac <http://lowendmac.com/lists/support.html> PCI-PowerMacs list info: <http://lowendmac.com/lists/pci-powermacs.shtml> --> AOL users, remove "mailto:"; Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> Archive:<http://www.mail-archive.com/pci-powermacs%40mail.maclaunch.com/> Using a Mac? Free email & more at Applelinks! http://www.applelinks.com
