7600, PowerLogic G3/4, 360mHZ running 9.0.4 on one drive (9G) and 8.6 on another (3G). I am wondering why my Apple Video Player causes a general freeze when I try to capture more than about 5 minutes of film off a VCR tape. This happens particularly when I have done a few successful captures and saves. It is as if the memory is not cleared properly. Anyone use this old software? I have VM turned off on the 8.6 disk (as recommended for this software) and have tried set the monitor to thousands and even a few times to greyscale (to cut down on processing load). I have given it much more memory than it recommends even. I have plenty of memory, all consistent branded and all 64K filling all slots, all tried and tested in practice for a long time. I assume that when this software is capturing things, it does this in RAM. I don't capture so much that the products are ever more than 3 or 400 MB. Have nothing else running. When I run on with VM on, things are not improved it seems. Anyone use this software that I can pester?
-- PCI-PowerMacs is sponsored by <http://lowendmac.com/> and... Small Dog Electronics http://www.smalldog.com | Refurbished Drives | -- Sonnet & PowerLogix Upgrades - start at $169 | & CDRWs on Sale! | Support Low End Mac <http://lowendmac.com/lists/support.html> PCI-PowerMacs list info: <http://lowendmac.com/lists/pci-powermacs.shtml> --> AOL users, remove "mailto:"; Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> Archive:<http://www.mail-archive.com/pci-powermacs%40mail.maclaunch.com/> Using a Mac? Free email & more at Applelinks! http://www.applelinks.com
