that simple! it was number 8, so extending the radiobutton to select the serial port was the simple solution! thank you gordo&roman!
i'll now start to mess around with a stepper motor h bridge and try to combine it with camera tracing, so i might be back with another question soon... thank you again! emanuel On 20 Feb 2007, at 11:41, Roman Haefeli wrote: > On Tue, 2007-02-20 at 01:34 +0100, media.gambler wrote: >> hello list! >> >> >> i'm trying to get my arduino board to run with pd. >> i work on a g4 powerbook, OS 10.4.8 with the latest installer from >> hans, Pd-0.39.2-extended-test7. >> >> >> the arduino works fine with processing, the blinking led test file >> works, so i upload the pd_firmware. >> >> >> when i open the arduino-help file everything seems to work fine, i >> can >> open a connection and get this message: >> [comport] opened serial line device 1 (/dev/tty.Bluetooth-PDA-Sync) >> - is this already wrong? is that the correct type of connection? > > i assume not. for example on my computer, the arduino is > on /dev/ttyUSB0 . to open that device with comport, i have to send a > message [open 8(. the help-file of arduino has only a radio, that > covers > the range from 0-7. but on many systems the right address is much > higher > than 7 (e.g 48). i don't know what is usual on osx, but i would try > any > number up to 100, until you see something like /dev/ttyUBS0 (this > is on > linux, don't know about osx). > > roman > > > > > ___________________________________________________________ > Telefonate ohne weitere Kosten vom PC zum PC: http:// > messenger.yahoo.de > _______________________________________________ [email protected] mailing list UNSUBSCRIBE and account-management -> http://lists.puredata.info/listinfo/pd-list
