On 05/26/2013 05:05 PM, James Dunn wrote:
Hi,
I have installed Arch linux on my Raspberry Pi and am logging in with
ssh -Y raspberrypi.local. I can run xterm fine over the connection but
pd fails with no information other than:
$ pd
priority 6 scheduling enabled.
priority 8 scheduling enabled.
watchdog: signaling pd...
pd: exiting
If I set the debug level to 5 I get the following information:
$ pd -d 5
this is of not much use unless you want to debug the pd<->gui connection.
try instead:
"-v" (for verbose)
"-v -v" (for more verbosity)
other flags you might want to check (in any combination)
"-nogui" (see whether Pd can start without the gui)
"-nosound" (does the sound-card give you trouble?)
"-noprefs" (stupid preference file?)
my bet is, that your soundcard is the culprit, e.g. Pd doesn't handle
the case well, where you only have half-duplex (e.g. playback only) and
your are using alsa. if that's the case ("-nosound" should run ok), try
"-noadc" or "-nodac" (without the "-nosound"))
famsdr
IOhannes
_______________________________________________
[email protected] mailing list
UNSUBSCRIBE and account-management ->
http://lists.puredata.info/listinfo/pd-list
