Thanks Jan! I just did that but have no clue what these parameters mean or how to change them. I have already created a /etc/init/ttyACM0.conf but don't know how to enter any correct values.
Here are (only) the differences of the two outputs: good midi in unit: bad midi in unit: -cstopb cstopb -clocal clocal ixon -ixon ixoff -ixoff opost -opost isig -isig icanon -icanon -iexten iexten echo -echo echoe -echoe If you (or anybody else) could give me a hint which of these settings might cause "13" to come out as "10" problem and how to change those settings I'd be extremely grateful! Ingo > -----Ursprüngliche Nachricht----- > Von: Pd-list [mailto:[email protected]] Im Auftrag von Fred Jan > Kraan > Gesendet: Samstag, 6. Februar 2016 16:33 > An: [email protected] > Betreff: Re: [PD] arduino ProMicro problem with no. "13" coming in as "10" > (Ubuntu 11.10) > > On 2016-02-06 03:00 PM, Ingo wrote: > > > > Does anybody have an idea how to fix this? > > You might try to compare the output of 'stty -a -F /dev/ttyACM0' on both > systems. It might be the newer Linux has a different idea about the > terminal type of /dev/ttyACM0. > > > > Thanks! > > Ingo > > > Greetings & success, > > Fred Jan > > _______________________________________________ > [email protected] mailing list > UNSUBSCRIBE and account-management -> > http://lists.puredata.info/listinfo/pd-list I'm having a strange problem with the transmission of my Arduino ProMicro MIDI interface on Ubuntu 11.10 (kernel 3.13). It shows up as ttyacm0 in the system. Every number "13" that I transmit which could be controller number "13" or a value like program change "13" comes in as number "10". I suppose it is being recognized as a carriage return (13) which is being executed and then followed by a line feed (10) that actually gets transmitted to the [comport] object for some reason. Does anybody have an idea how to fix this? Is there a ttyacm.conf (or similar) somewhere in the system that I could edit for a normal (non modem) behavior? Or can I set up the arduino to show up as a different device other than ttyacm? On my other operating system everything is working fine with the same arduino and programming coming in as ttyacm0 - no special changes. Just another Ubuntu 11.10 with an older (original 2.6) kernel. Thanks! Ingo _______________________________________________ [email protected] mailing list UNSUBSCRIBE and account-management -> http://lists.puredata.info/listinfo/pd-list
