I'm not quite sure I understand your patching approach enough to debug. If it's at all helpful, I can suggest how I might do this via [clone -n 1] with 72 instances of an abstraction:
[inlet] | [route freq gain] | [osc] | [*~ 0.25] <-- perhaps some trim amount as lots of osc are being summer | [*~ ] <--- single osc gain value goes here | [outlet~] The outlets are summed in clone through the output. If you need stereo, it's the same just with two [outlet~]s and some sort of panner. UDP messages would then just need to have the gain values read and applied to the clone instances by their ID, ie. [1 gain 0.25 | [clone 72 -n 1 orc-abs] | [*~ ] <--- master gain | [dac~] <-- or some similar output abstraction Not knowing your networking message layout, I can't say anything else other than "use OSC" as addressing and arguments are relatively easy to work with via: [netreceive -u -b] | [oscparse] | perhaps some routing etc | [clone] > On Mar 14, 2021, at 3:31 AM, [email protected] wrote: > > Date: Sun, 14 Mar 2021 03:31:23 +0100 > From: Michael Karr <[email protected] > <mailto:[email protected]>> > To: [email protected] <mailto:[email protected]> > Subject: [PD] Adding up a thicket of oscillators > Message-ID: > <CAOH2gpZ=gukk4x_kmoku3heocc92_xs-ggvta0irdwptthd...@mail.gmail.com > <mailto:CAOH2gpZ=gukk4x_kmoku3heocc92_xs-ggvta0irdwptthd...@mail.gmail.com>> > Content-Type: text/plain; charset="utf-8" > > Hello! > > I am working on a multichannel sound piece, with 72 oscillators, receiving > data from ffmpeg over udp. Each oscillator stream has its own intensity > fluctuations. However, when I try to add the dynamic parts and scale them > collectively (using *~ and a very tender slider), I get no output, whereas > adding up the raw oscillators does produce audio, minus the individual > fluctuations. > > 1) how do I combine all of these dynamic signals? > 2) how can I make else/count start counting the moment information starts > flowing through the udp port, and stop again once the feed stops, while > keeping the connection active? > > > Kind regards, > Michael
_______________________________________________ [email protected] mailing list UNSUBSCRIBE and account-management -> https://lists.puredata.info/listinfo/pd-list
