Just kidding.
I use Clear Sight and a clean piece of old underwear, briefs, not boxers on the DCS460's sensor.
http://www.clearsightusa.com/ecommerce/catalog/catalog/index.php?cPath=21
I haven't needed to use it yet on the isDS.
Jim
Tom C wrote:
FWIW, I don't think that blowing with a high speed stream of air just blows it around inside the camera. The camera body is quite a shallow 'well'. I suspect, and practice seems to back up, that dust (at least the vast majority) is blasted out the front, since the air stream is reflected and directed back, that's the only place it has to go. Not trying to forcefully argue the point.
It just seems to me that there's so much excess angst regarding sensor cleaning and the infinite splitting of hairs over *the* method.
Manufacturers of cleaning systems and supplies have much to gain by making this a critical issue.
In my particular circumstances and usage I don't find sensor dust to be a major issue. I've never had anything actually stuck on the sensor. Just small pieces of dust laying on it. I clean the sensor, it takes less than 30 seconds, and I'm back shooting again.
Tom C.
From: "David Zaninovic" <[EMAIL PROTECTED]> Reply-To: [email protected] To: <[email protected]> Subject: Re: CCD cleaning Date: Wed, 9 Mar 2005 13:07:54 -0500
I don't know, maybe it is not possible to get stuck dust from compressed air but I don't need to use it any more since pec pads work
fine and actually remove the dust, not just move it around in the camera.
----- Original Message ----- From: "Tom C" <[EMAIL PROTECTED]> To: <[email protected]> Sent: Wednesday, March 09, 2005 11:54 AM Subject: RE: CCD cleaning
> I find it hard to understand how using compressed air would *make* dust
> stick to a CCD, unless fluid was deposited with the air. That's easily
> avoidable.
>
> With so much talk about cleaning swabs and fluids, I have to point out one
> obvious thing. Air is far less likely to do damage to the CCD than actually
> physically touching and 'scrubbing' it .
>
> My method is to use the compressed air can with the straw. Hold upright and
> spray a two second burst away from the camera to eliminate any propellant or
> fluid. Then spray into the camera for 5 seconds or so.
>
> I've had the *ist D for 13 months. I've cleaned the sensor 5 times.
> Anyway, that's my experience.
>
> Tom C.
>
>
>
> >From: "David Zaninovic" <[EMAIL PROTECTED]>
> >Reply-To: [email protected]
> >To: <[email protected]>
> >Subject: CCD cleaning
> >Date: Wed, 9 Mar 2005 09:41:25 -0500
> >
> >I was cleaning my CCD yesterday with copperhill method. I did not destroy
> >my CCD. :)
> >It was quite easy, I needed 4 pec-pads to remove 99% of the dust. I still
> >have some left, I think it is stuck so it will need more
> >cleanings to go away. It is probably stuck because of me using the
> >compressed air. I will not use compressed air or bulb blower
> >any more.
> >I did not find it hard to wrap pec pads around spatula as I thought by
> >reading all the instructions and peoples opinions.
> >
>
>
