You will have to be a little more specific on this one... at least
attach your config files so we can see where the problem could be.
You are sure it's not a firewall issue, right?
On 12/31/2010 04:16 AM, [email protected] wrote:
Hi,
I have another question.
On another computer that is connected directly to the internet and has a
static ip, I have the same powerdns configuration and I can't get the
SOA nameserver to respond to queries from the slave nameservers.
Do you think the problem could be in pdns.conf?
Any help would be greatly appreciated.
Regards,
Don James
On 12/29/2010 12:59 AM, Imre Gergely wrote:
Hi
For MNAME in the SOA record you should have your primary nameserver,
like ns1.donaldbjames.info. It definitely should be one of the
nameservers of the domain, one of these:
;; ANSWER SECTION:
donaldbjames.info. 86332 IN NS b.ns.buddyns.com.
donaldbjames.info. 86332 IN NS ns1.twisted4life.com.
donaldbjames.info. 86332 IN NS ns1.donaldbjames.info.
donaldbjames.info. 86332 IN NS ns2.afraid.org.
The SOA should be something like:
donaldbjames.info. 86400 IN SOA ns1.donaldbjames.info.
donaldbjames.suddenlinkmail.com. 2010122811 10800 3600 604800 3600
As for the recursor and auth server running at the same time, you must
have them listen on two separate IP addresses if you want to run them
both on port 53. This would be the recommended way.
You could also have pdns-recursor listen on another port, say 53000 and
then set the recursor= option in the auth server to forward requests to
the recursor. This is not recommended but you can do it if you have a
small site, or you just use the recursor on localhost. But then you
could bind the recursor to 127.0.0.1 and the auth server to whatever
other IP address you have on the box.
On Tue, 28 Dec 2010 20:46:05 -0600, [email protected] wrote:
Hi folks,
I managed to get powerdns configured and running. I used poweradmin
to enter the zone data for my SOA zones.
However, when I check my configuration with http://www.intodns.com, I
get the following error:
SOA MNAME entry WARNING: SOA MNAME (donaldbjames.info) is not
listed as a primary nameserver at your parent nameserver!
My zone is donaldbjames.info. If you like, go to http://www.intodns.com
type in "donaldbjames.info" in the box at the top, click on "report",
wait a few minutes and then scroll down the page. You will see a
yellow box with a warning.
I am at a loss to figure out what setting is missing in my powerdns
setup.
Another thing: When I try to run the pdns-recursor, it won't start
while the SOA nameserver is running. They both bind to port 53. I
tried running the pdns-recursor on port 5300. It will start but won't
act as a caching nameserver.
Any help would be greatly appreciated.
Regards,
Don James
_______________________________________________
Pdns-users mailing list
[email protected]
http://mailman.powerdns.com/mailman/listinfo/pdns-users
--
Imre Gergely
Yahoo!: gergelyimre | ICQ#: 101510959
MSN: gergely_imre | GoogleTalk: gergelyimre
gpg --keyserver subkeys.pgp.net --recv-keys 0x34525305
_______________________________________________
Pdns-users mailing list
[email protected]
http://mailman.powerdns.com/mailman/listinfo/pdns-users
