Hi,
I use an even simpler method -
Place polygon as normal, only:
Change the track placement mode to arcs using SHIFT+SPACEBAR
Define the polygon boundary in four 90� arcs. You will need to get each
arc exactly on the correct grid, or else the arc turns inside out!
Regards
David Watling
"John
Branthoover"
<[EMAIL PROTECTED] To
tronic.com> "Protel EDA Forum"
Sent by: <[email protected]>
[EMAIL PROTECTED] cc
servinc.com
Subject
[PEDA] Is Their A Way To Do A
03/02/2005 22:41 Circular Copper Pour?
Please respond to
Protel EDA
Discussion List
<[EMAIL PROTECTED]
.com>
Hello All,
I have a circular (round) PCB design. I would like to do a
copper pour
(polygon) on the bottom of the board. I would like the pour to follow the
outline of the board as close as possible. Does anyone have any nice
tricks
up their sleeve to accomplish this task?
Thank you for your time and have a nice day.
John Branthoover :
Electrical Design Engineer :
Acutronic USA, Inc. :Phone (412) 968-1051
640 Alpha Drive :Fax (412) 963-0816
Pittsburgh PA 15238 :Email [EMAIL PROTECTED]
USA :WEB http://www.acutronic.com
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
