Hello All,
I have a PCB design that has several ground planes in it. I have all of
the ground vias directly connected to the planes. I have all of the
thru-hole components grounds connected using thermal reliefs. If I look at
the PCB with the internal planes tab selected and with the multi layer view
option turned off, I see the thermal reliefs.
When I generate the gerbers using the embedded apertures (RS274X), most
of
the thermal reliefs are gone. This only happens with the power planes. I
have several polygons in this design and their thermal reliefs are intact.
Has anyone else seen this? Does anyone know what I am doing wrong? Any
information that you can give me will be greatly appreciated. Thank you for
your time.
John Branthoover :
Electrical Design Engineer :
Acutronic USA, Inc. :Phone (412) 968-1051
640 Alpha Drive :Fax (412) 963-0816
Pittsburgh PA 15238 :Email [EMAIL PROTECTED]
USA :WEB http://www.acutronic.com
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
