Thank you Dennis,
Don't see them that often but they are a nuisance and source of worry
over database integrity when you do get them. I had never zeroed in on what I
finally did to get rid of them, there were all sorts of contortions.
Sincerely,
Brad Velander
Senior PCB Designer
Northern Airborne Technology
1925 Kirschner Rd.,
Kelowna, BC, V1Y 4N7.
tel (250) 763-2329 ext. 225
fax (250) 762-3374
-----Original Message-----
From: Dennis Saputelli [mailto:[EMAIL PROTECTED]
Sent: April 27, 2005 6:57 PM
To: Protel EDA Discussion List
Subject: Re: [PEDA] phantom ratsnest 99SE
didja ever see a phantom ratsnest in 99SE ?
i do from time to time
they go to a point in 'air' with nothing at the end which can be deleted
they don't seem to really matter but it bugs me
i tried saving as ascii and many other things to no avail
now i found a method to kill them
do a place track (copper)
start it at the end of the phantom point (it should snap to it with
E-snap on)
route to a valid point
isolate that segment or segements if they go all over the place
then select connected copper and hit ctrl delete
Dennis Saputelli
_______________________________________________________________________
Integrated Controls, Inc. Tel: 415-647-0480 EXT 107
2851 21st Street Fax: 415-647-3003
San Francisco, CA 94110 www.integratedcontrolsinc.com
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
