Hi Pallav, The procedure for 4 layer PCB design starting with a schematic is too detailed and I too had a similar problem when I started with Protel99.
However if you read the handbook you will be able to start designing in a couple of days. Here is a link to the handbook. http://www.petech.ac.za/elec_project/zip/Protel/handbookp99se.pdf Best regards, Paresh Pai ----- Original Message ----- From: "virender gupta" <[EMAIL PROTECTED]> To: <[email protected]> Sent: Saturday, May 28, 2005 12:02 PM Subject: [PEDA] help me please > hi, > i m new to multilayer pcb designing,plz help me making a simple 4 layer pcb design(2 signal layer and 2 power planes) > please give me step by step method how to make a simple circuit and then its 4 layer pcb in protel99SE software. > > any help will be appreciated. > > with best regards > pallav aggarwal > > > --------------------------------- > Yahoo! Mail Mobile > Take Yahoo! Mail with you! Check email on your mobile phone. > > ____________________________________________________________ > You are subscribed to the PEDA discussion forum > > To Post messages: > mailto:[email protected] > > Unsubscribe and Other Options: > http://techservinc.com/mailman/listinfo/peda_techservinc.com > > Browse or Search Old Archives (2001-2004): > http://www.mail-archive.com/[email protected] > > Browse or Search Current Archives (2004-Current): > http://www.mail-archive.com/[email protected] > ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
