Place Keep out lines, arcs, & circles on those layers. Place>Keepout
Regards, Steve Smith, C.I.D. Product Engineer Staco Energy Products Co. Web Site: www.stacoenergy.com & www.stacopower.com > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] Behalf Of Brad Kosiance > Sent: Tuesday, July 26, 2005 4:43 PM > To: [email protected] > Subject: [PEDA] Speaking of keepout layers ... > > > Since the keep out layer is not assigned to a specific copper > layer what if > you want different keep out areas on the top layer and bottom layer? > > > > Thanks, > > Brad. > > > ____________________________________________________________ > You are subscribed to the PEDA discussion forum > > To Post messages: > mailto:[email protected] > > Unsubscribe and Other Options: > http://techservinc.com/mailman/listinfo/peda_techservinc.com > > Browse or Search Old Archives (2001-2004): > http://www.mail-archive.com/[email protected] > > Browse or Search Current Archives (2004-Current): > http://www.mail-archive.com/[email protected] > > ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
