tastingfan,
First of all, since your question is about DXP rather than P99SE, your
question would be better asked on the Altium DXP forum. we're mostly a bunch of
P99SE hold-outs on this forum with minimal experience with DXP.
However to answer your question generically, it sounds like the
footprint specified for R3 was not found in the libraries. Therefore it could
not make your net connections to two pins of the device, nor add it to the
class. There is most likely another error message that you didn't see or
mention that tells you the footprint was not found.
This type of error will let you move forward but be quite assured that
there is something missing within your PCB design. Most likely the connections
to R3 and possibly the footprint for R3 itself.
Sincerely,
Brad Velander
Senior PCB Designer
Northern Airborne Technology
1925 Kirschner Rd.,
Kelowna, BC, V1Y 4N7.
tel (250) 763-2329 ext. 225
fax (250) 762-3374
-----Original Message-----
From: tastingfan tastingfan [mailto:[EMAIL PROTECTED]
Sent: July 26, 2005 8:06 PM
To: [email protected]
Subject: [PEDA] some errors when updating
Hi,
When I execute Design->Update PCB Document *.pcbdoc in Protel 2004, some errors
occur
Unknown Pin: Pin R3-1
Unknown Pin: Pin R3-2
Failed to add class member: Component R3 Res2
but still I get the work done, why?
Best Regards
Tasting_fan
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
