i wondered too, since i know nothing about PADS/POWERPCB i will inquire
so does anyone know if the current version improves on plane DRC ?
ds
_______________________________________________________________________
Integrated Controls, Inc. Tel: 415-647-0480 EXT 107
2851 21st Street Fax: 415-647-3003
San Francisco, CA 94110 www.integratedcontrolsinc.com
Brad Velander wrote:
Dennis,
Please elaborate on this supposed PADs "minimum amount of copper" DRC.
What is it's precise name? Where is it? Since I don't think that I have seen this DRC
rule I am wondering is it, in some advanced/special PADs module that we don't have?
Sincerely,
Brad Velander
Senior PCB Designer
Northern Airborne Technology
#14 - 1925 Kirschner Road,
Kelowna, BC, V1Y 4N7.
tel (250) 763-2329 ext. 225
fax (250) 762-3374
-----Original Message-----
From: Dennis Saputelli [mailto:[EMAIL PROTECTED]
Sent: Thursday, September 22, 2005 9:51 AM
To: Protel EDA Discussion List
Subject: Re: [PEDA] plane voids causing disconnect DRC'd in DXP?
the PADs 'minimum amount of copper' DRC implied by my friend would have
flagged such a situation
does Protel 2004 address this ? or are there plans to ?
would this also apply to the situation of a rounded track end just
barely grazing the edge of a pad which passes protel continuity but
would probably fab as a break?
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
