Simon,
Sounds like an inch verses mil issue with the DXF. Check to see what
base your DXF export is using and what PADs wants as it's default if it is not
selectable at the time of the PADs import.
Sincerely,
Brad Velander
Senior PCB Designer
Northern Airborne Technology
#14 - 1925 Kirschner Road,
Kelowna, BC, V1Y 4N7.
tel (250) 763-2329 ext. 225
fax (250) 762-3374
-----Original Message-----
From: Simon Lightbody [mailto:[EMAIL PROTECTED]
Sent: Monday, November 07, 2005 8:42 AM
To: [email protected]
Subject: [PEDA] Re: DXF export from Camtastic
Thanks for the help. I was trying to use Camtastic to export a board outline to
be imported by an external vendor doing the board layout in Power PCB. When he
imported it, he said it was 1000 times too small. I tried importing the file
into a shareware dxf viewer (Acme CadSee) and it also appeared 1000 times too
small there. I can't find any configuration parameters in Camtastic, so I'm
stuck. I do have a little bit of information at negative coordinates
(comments), but the board is definitely less than 40x40 inches. Any ideas,
thanks.
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
