Adeel, place two arcs, one on top one on the bottom Layer und make them a keepout by dobleclicking on them and selekt the "keepout"-Box.
Regards, Waldemar ______________________________________________________________________ Waldemar Kulajew Entwicklung Drehgeber/Sensorik ______________________________________________________________________ Fritz Kuebler GmbH Tel.: +49-7720-3903-44 Schubertstrasse 47 Fax: +49-7720-3903-306 78054 Villingen-Schwenningen http://www.kuebler.com mailto:[EMAIL PROTECTED] ceterum censeo, Microsoftinem esse delendam > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of Adeel Malik > Sent: Friday, November 18, 2005 12:36 PM > To: [email protected] > Subject: [PEDA] Circular Copper Pour > > Hi All, > I intend to do circular Copper Pour on Top Layer > and Bottom Layer of a double-sided round PCB. Can some one > tell me how to accomplish that easily?. > > Regards, > Adeel Malik > > > ____________________________________________________________ > You are subscribed to the PEDA discussion forum > > To Post messages: > mailto:[email protected] > > Unsubscribe and Other Options: > http://techservinc.com/mailman/listinfo/peda_techservinc.com > > Browse or Search Old Archives (2001-2004): > http://www.mail-archive.com/[email protected] > > Browse or Search Current Archives (2004-Current): > http://www.mail-archive.com/[email protected] > > > *********************************************** > > Mail scanned by Viruswall.kuebler.com > > ********************************************************************** Mail scanned by viruswall.kuebler.com ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
