In case you run into problems, bear in mind, that the current release of 6.0 has a feature where you can flip the backside of the PCB to place & route.
Regards TDK -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Taz Who Sent: Monday, January 02, 2006 11:10 AM To: [email protected] Subject: [PEDA] Installing Servers In DXP2004 SP4....? Hello All, Is there a way to install servers in DXP2004 SP4? I would like to use the CSFlip Viewer from Considered Solutions. It allows you to view your PCB from the bottom. I briefly used it long ago in a prior life running under Protel 99SE. It worked great! In DXP2004 SP4, I can not seem to find the area to install servers. Any information that you can give me will be greatly appreciated. Thank you for your time and have a nice day. ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected] ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
