Steve Hendrix wrote:
> At 2006-03-27 22:47 +0800, you wrote:
>> One of the parts I created, I deleted the part from the schematic, went
>> into the library, made sure that the end of the pin with the BLOB is
>> away from the part, made all the pins the right type (power, input
>> output) and saved the library, removed the library, re added it, put the
>> part back from the library. Still the same fault :(
>
> I recall the visual indicator being a bit misleading in this regard.
> Best way to know where the hotspot is, as described earlier, is to
> run a wire across the entire length of the pin, extending beyond it
> on both ends. This will cause an autojunction at the hotspot, so
> there will be no question where it is.
>
> It sounds like you're on the right track with removing and adding the
> library back, but you might still have a problem with the parts being
> cached, especially if there are still instances of that part on the
> schematic. Try (from the lib editor, with the schematic also open)
> "Update Schematic". You might even have to go so far as to create a
> different name for the part in order to be absolutely sure you're
> getting the new part.
>
> How about the specifics of one particular ERC error that's still
> giving you trouble. I was confused by your original post, which tried
> to cover a lot of ground at once. If you can delineate one specific
> error, I or someone else here can probably track it down.
>
> Steve Hendrix
This is all the errors I get(bellow text), BUT as I said, Take Error #1
U5 is a ATmega128, Pin 42 is the A15 pin (Address bus (this pin is an IO
pin in the library as it can be either GPIO or Address output)
The only other thing I have on A15 is a Flash Ram Chip, the A15 Pin on
this is an input.
This is the part in the netlist:
(
A15
U5-42
U7-11
)
So you can see it is FINE in the netlist.
Error Report For : Main.Sch 27-Mar-2006 23:37:31
#1 Error Unconnected IO Pin On Net A15
CPU Ram and Flash Rom.Sch(U5-42 @370,550)
#2 Error Unconnected IO Pin On Net A16
CPU Ram and Flash Rom.Sch(U5-4 @370,510)
#3 Error Unconnected Passive Pin On Net BD5
Ehternet.Sch(R6-2 @430,550)
#4 Error Unconnected Passive Pin On Net CS4
PSU LCD FP RESET.Sch(J4-6 @990,870)
#5 Error Unconnected Passive Pin On Net IOCS16B
Ehternet.Sch(R1-2 @430,840)
#6 Error Unconnected Passive Pin On Net LED0
Ehternet.Sch(R3-1 @930,550)
#7 Error Unconnected Passive Pin On Net LED1
Ehternet.Sch(R4-1 @930,520)
#8 Error Unconnected Output Pin On Net NCS2
CPU Ram and Flash Rom.Sch(U8-13 @250,470)
#9 Error Unconnected Output Pin On Net NCS3
CPU Ram and Flash Rom.Sch(U8-12 @250,460)
#10 Error Unconnected Output Pin On Net NCS4
CPU Ram and Flash Rom.Sch(U8-11 @250,450)
#11 Error Unconnected IO Pin On Net NINT0
CPU Ram and Flash Rom.Sch(U5-8 @370,470)
#12 Error Unconnected Input Pin On Net NRESET
CPU Ram and Flash Rom.Sch(U5-20 @580,410)
#14 Error Floating Input Pins On Net NRESET
Pin CPU Ram and Flash Rom.Sch(U5-20 @580,410)
#15 Error Unconnected Passive Pin On Net NetC27_1
Ehternet.Sch(C27-1 @920,800)
#16 Error Unconnected Passive Pin On Net NetC28_1
Ehternet.Sch(C28-1 @950,800)
#17 Error Unconnected Passive Pin On Net NetC29_1
Ehternet.Sch(C29-1 @990,800)
#18 Error Unconnected Passive Pin On Net NetC30_1
Ehternet.Sch(C30-1 @1020,800)
#19 Warning IO Pins And Output Pins On Net RX
IO Pins : CPU Ram and Flash Rom.Sch(U5-27 @710,600)
Output Pins : PSU LCD FP RESET.Sch(U14-12 @1050,350)
#20 Error Unconnected Passive Pin On Net TPIN+
Ehternet.Sch(R2-2 @920,690)
#21 Error Unconnected Passive Pin On Net TPIN-
Ehternet.Sch(R2-1 @920,620)
#22 Error Unconnected Passive Pin On Net WE
PSU LCD FP RESET.Sch(J4-5 @990,880)
End Report
--
Regards,
Kat.
---------------------------------------------------------------
K.A.Q. Electronics Website: www.kaqelectronics.dyndns.org
IM: Yahoo: PinkyDwaggy MSN: [EMAIL PROTECTED]
For Everything Electronics Phone: 0419 923 731
---------------------------------------------------------------
--
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.1.385 / Virus Database: 268.3.2/293 - Release Date: 26/03/2006
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
