I don't remember 98 anymore but in 99 there is a setting for whether or not to ask for a reference point i imagine the setting is there and that it is off couldn't tell you where to look though
Dennis Saputelli _______________________________________________________________________ CONTACT INFORMATION: _______________________________________________________________________ Integrated Controls, Inc. Tel: 415-647-0480 EXT 107 2851 21st Street Fax: 415-647-3003 San Francisco, CA 94110 www.integratedcontrolsinc.com _______________________________________________________________________ NOTE! TO PASS OUR SPAM FILTER PUT THE FOLLOWING IN SUBJECT LINE: I.C.I. Steve Bartlett wrote: > Hi all, > for some reason, when I attempt to do a block copy of selected portions > of a schematic, using ctrl-c afterhi-lighting does not make the cursor a > cross-hair to select a reference point anymore. Upon using ctrl-c the > screen simply refreshes and wherever the mouse was at that time will be > used as the reference point. > I've looked in the doc and online 'help' for possible clues but found no > 'settings' that could affect this. Any ideas? Steve > ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
