Hi, The few times I have used it I have had real problems with split planes and other items. I also have an extensive set of libraries for SCH that I cannot figure out how to convert to 99SE schematic libraries and the same for my PCB libraries. None of this is an obvious migration path and I have not had the time to fuss with it. I am just too busy trying to run my business so I have lived with the old stuff. If there was a document on migration I might try to make some progress but I have not found anything. Thanks,
At 12:00 PM 7/11/2007 -0500, [EMAIL PROTECTED] wrote: >Date: Wed, 11 Jul 2007 09:10:58 -0400 >From: <[EMAIL PROTECTED]> >Subject: Re: [PEDA] Anyone Using Adv Sch 3.2? >To: <[email protected]> >Message-ID: > <[EMAIL PROTECTED]> >Content-Type: text/plain; charset="us-ascii" >Not using it, no. >If you already own P98 or P99SE, then IMO it's time to make the move. >We're going on eight (8) years since it's release...! And though I'll >freely admit I'm not equipped personally to do the following, it's quite >likely that one or more of the more advanced members of this group can >advise you on moving your active design from the V3 environment to P99SE >with little or no pain. >Good luck, >aj > > >-----Original Message----- > >From: [EMAIL PROTECTED] > >[mailto:[EMAIL PROTECTED] On Behalf Of Robert Ritchey > >Sent: Tuesday, July 10, 2007 7:05 PM > >To: [email protected] > >Subject: [PEDA] Anyone Using Adv Sch 3.2? > >Hi, > >Anyone out there still use Adv Sch 3.2 at all? I have had a > >really strange thing happen to me. I am not sure if an XP > >update bit me or what. When I go to the open dialog I cannot > >see any files on my E: drive except for 1. > >I have tried all directories and the only file I can see is > >one that I was editing a week back. It also will not save the > >libraries when I add them. It seems like it will not write > >the AdvSch.ini file at all. Strange thing is, I got a D-Link > >NAS and I moved some of the project folders to it and I can > >read them there but it still will not update the AdvSch.ini > >file. If I change any shortcuts they do not last after I > >exit. I know I should move to 99SE but it is so fast to do > >small boards in this and AdvPCB that I still use it. This all > >worked a month ago, now it doesn't. Any thoughts would be > >greatly appreciated. > >Thanks, -Bob -------------------------------------------------------------------- Robert Ritchey Quest Engineering & Development 1328 East Cottonwood Lane Phoenix, AZ 85048-4765 Tel: (480) 460-2652 FAX: (480) 460-2653 E-Mail: [EMAIL PROTECTED] E-Mail: [EMAIL PROTECTED] E-Mail: [EMAIL PROTECTED] E-Mail: [EMAIL PROTECTED] WWW: www.QuestEngDev.com/ WWW: www.Smart-Fly.com/ -------------------------------------------------------------------- ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[EMAIL PROTECTED] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
