On Sun, Jul 03, 2005 at 05:09:05PM +0100, Dave Mitchell wrote:
> On Sun, Jul 03, 2005 at 01:57:00PM +0200, [EMAIL PROTECTED] wrote:
> > Automated smoke report for 5.9.3 patch 25055
> > fixit.xs4all.nl: Pentium II (i386/1 cpu)
> > on bsd/os - 4.1
> > using cc version egcs-2.91.66 19990314 (egcs-1.1.2 release)
> > smoketime 3 hours 56 minutes (average 1 hour 58 minutes)
> >
> > Summary: FAIL(F)
> >
> > O = OK F = Failure(s), extended report at the bottom
> > X = Failure(s) under TEST but not under harness
> > ? = still running or test results not (yet) available
> > Build failures during: - = unknown or N/A
> > c = Configure, m = make, M = make (after miniperl), t = make test-prep
> >
> > 25055 Configuration (common) none
> > ----------- ---------------------------------------------------------
> > F F - - -Duse64bitint
> > O O - -
> > | | | +----- PERLIO = perlio -DDEBUGGING
> > | | +------- PERLIO = stdio -DDEBUGGING
> > | +--------- PERLIO = perlio
> > +----------- PERLIO = stdio
> >
> >
> > Failures: (common-args) none
> > [stdio/perlio] -Duse64bitint
> > ../t/op/int.t...........................FAILED 11
> >
>
> Has anyone looked into this at all?
>
> It's this test:
>
> $x = 4294967295.7;
> $y = int ($x);
>
> if ($y eq "4294967295") {
> print "ok 11\n"
> } else {
> print "not ok 11 # int($x) is $y, not 4294967295\n"
> }
>
> would be interesting to see what value $y actually has.
I tried emailing Jos at various addresses asking for verbose test
output, but got no response. Perhaps mentioning it in a
CPANPLUS-related post will get his attention.
