Hi Karli, I ran a test build last night and it failed. It was a relatively simple configuration where I was downloading mpich and cmake and building with threads, cuda and the txpetscgpu package. I was building on a Fedora 17 machine with Cuda 5. The failure seem to be associated with cmake. When I get home this evening, I could send you the configure and make logs. I did not have time this morning before leaving for work. I wanted to give you some early feedback even though the logs will have to wait till this evening.
Thanks, Dave -- Dave Nystrom LANL HPC-5 Phone: 505-667-7913 Email: wdn at lanl.gov Smail: Mail Stop B272 Group HPC-5 Los Alamos National Laboratory Los Alamos, NM 87545 ________________________________________ From: petsc-dev-bounces at mcs.anl.gov [petsc-dev-bounces at mcs.anl.gov] on behalf of Karl Rupp [r...@mcs.anl.gov] Sent: Tuesday, March 19, 2013 4:04 PM To: petsc-dev at mcs.anl.gov Subject: Re: [petsc-dev] CMake-assisted CUDA builds ready Hi Dave, perfect, thanks! I should add that a reconfigure is needed. It won't work with re-running make only. Best regards, Karli On 03/19/2013 04:59 PM, Nystrom, William D wrote: > Hi Karli, > > I will try this soon and report back when I have results. > > Thanks, > > Dave > > ________________________________________ > From: petsc-dev-bounces at mcs.anl.gov [petsc-dev-bounces at mcs.anl.gov] on > behalf of Karl Rupp [rupp at mcs.anl.gov] > Sent: Tuesday, March 19, 2013 3:58 PM > To: For users of the development version of PETSc > Subject: [petsc-dev] CMake-assisted CUDA builds ready > > Dear all, > > I just merged the CMake-based builds for CUDA-packages into 'next', > reducing compilation times considerably compared to the old legacy > builds. While the legacy builds print something like > 'libfast in <DIR>' > the new CMake-based builds print the usual percentage counters in front. > > Any feedback on the proper functionality (both positive and negative) > are appreciated. > > Thanks and best regards, > Karli >