On Wed, Feb 10, 2016 at 7:33 PM, Michele Rosso <[email protected]> wrote:
> Hi, > > I encountered the following error while solving a symmetric positive > defined system: > > Linear solve did not converge due to DIVERGED_PCSETUP_FAILED iterations 0 > PCSETUP_FAILED due to SUBPC_ERROR > > This error appears only if I use the optimized version of both petsc and > my code ( compiler: gfortran, flags: -O3 ). > It is weird since I am solving a time-dependent problem and everything, > i.e. results and convergence rate, are as expected until the above error > shows up. If I run both petsc and my code in debug mode, everything goes > smooth till the end of the simulation. > However, if I reduce the ksp_rtol, even the debug run fails, after running > as expected for a while, because of a KSP_DIVERGED_INDEFINITE_PC . > The options I am using are: > > -ksp_type cg > -ksp_norm_type unpreconditioned > -ksp_rtol 1e-8 > -ksp_lag_norm > -ksp_initial_guess_nonzero yes > -pc_type mg > -pc_mg_galerkin > -pc_mg_levels 4 > -mg_levels_ksp_type richardson > -mg_coarse_ksp_constant_null_space > -mg_coarse_pc_type lu > -mg_coarse_pc_factor_mat_solver_package superlu_dist > -options_left > > I attached a copy of ksp_view. I am currently using petsc-master (last > updated yesterday). > I would appreciate any suggestion on this matter. > I suspect you have a nonlinear PC. Can you send the output of -ksp_view? Matt > Thanks, > Michele > > > > > > > > -- What most experimenters take for granted before they begin their experiments is infinitely more interesting than any results to which their experiments lead. -- Norbert Wiener
