Has anyone tried to define a label format that has no margins? I'm trying to set up a label for an APLI 1273 A4 label sheet where the label is 7cm wide and 3.7cm high, 3 across, 8 down. On an A4 sheet, that means there can't be any margin (actually there is a slight top margin, i.e., L=0, R=0, B=0, T=.05), since 3 x 7cm is 210mm, the width of the sheet itself. Powerbuilder doesn't appear to allow for a label sheet that uses the entire page. Even if I set up margins for the label as 0, I still get the blue "printable area of the page" square that forces the labels to start too far in and down. Am I just missing something? Any ideas would be appreciated. We're using PB6.5 and PFC Thanks! Van Sederburg > [EMAIL PROTECTED] HOSTED BY IIGG, INC. FOR HELP WITH LIST SERVE COMMANDS, ADDRESS > A MESSAGE TO [EMAIL PROTECTED] WITH THE FOLLOWING MESSAGE: help pfcsig > SEND ALL OTHER INQUIRES TO [EMAIL PROTECTED]
