Hi Ivan, I'm not sure why it is not finding it. Perhaps the configure.log file that is created will shed some light on the problem.
Adam; do you have any ideas? Regards, Dave. > -----Original Message----- > From: pginfo [mailto:[EMAIL PROTECTED] > Sent: 14 September 2003 09:29 > To: Dave Page > Cc: [EMAIL PROTECTED] > Subject: Re: [pgadmin-support] problem installing pgAdmin 3 > on red hat 7.3 > > > Hi Dave, > thanks for the answer. > I made pg install from source and I can find the *.h file. > It is exact into /usr/local/pqsql/include. > I got --with-pgsql=/usr/local/pgsql , but the configure > report the same message. About with file is ./configure > searching? regards, ivan. > > Dave Page wrote: > > > It's rumoured that pginfo once said: > > > Hi, > > > I try to install the latest pgAdmin3 on my workstation. > > > It is running red hat 7.3. > > > I make the installation from source. > > > By running ./configure I got this message: > > > you must specify a valid pgsql instalation wit --with-pgsql=DIR. > > > > > > I installed also the latest pg 7.3.4. ( I do not deen it on my > > > workstation), but I do not know where is this pgsql > instalation dir. > > > > Hi Ivan, > > > > Unless you specified an alternate location using the > --prefix= option > > when configuring PostgreSQL, then it should be in > /usr/local/pgsql if > > you installed from source. If you installed from an RPM, > then I'm not > > sure where it will be - can you find libpq-fe.h on your system? > > Regards, Dave. > > > > ---------------------------(end of broadcast)--------------------------- TIP 2: you can get off all lists at once with the unregister command (send "unregister YourEmailAddressHere" to [EMAIL PROTECTED])
