Justin Georgeson <[EMAIL PROTECTED]> writes:
> I'm not sure what you mean you're doing when you say you stop it with 
> ctrl-c, but you can use the pg_ctl utility, or `service postgresql stop` 
> to stop it. Then you should be able to start with the command you 
> listed, although you probably want to use pg_ctl or `service postgresql 
> start` instead.

> shreedhar wrote:
>> i am getting following error message.
>> StreamServer Port : bind() failed : Address already in use.
>> is another postmaster already running on port 5432
>> If not, wait a few seonds, and retry

I'm also wondering whether shreedhar has followed the advice given in
the error message: wait a bit and try again to start the postmaster.
On some Unixen it's impossible to reassign a particular listening port
number until the previous owner has been dead awhile (where "awhile"
is usually measured in "a few minutes").

                        regards, tom lane

---------------------------(end of broadcast)---------------------------
TIP 6: Have you searched our list archives?

http://archives.postgresql.org

Reply via email to