A whole host of them, mostly about bad data formats in some of the table
data. I suspect the underlying problem is that something got mangled in
the table creates.
I'm setting up on a different box as my attempt to create a second
instance failed horribly - compiling with a different prefix and port
number appears to work but when you do an "initdb" it blows up with a
complaint about not being able to create the semaphores and shared
segment. It appears the port number is used for the SEMID and SHMID
prefixes, and those for some reason are not getting reset (it may be
that the change in configure requires a gmake clean; not sure)
In any event I have another machine and will get something more detailed
ASAP - I will also try the "restore" program and see if that works.
Karl Denninger ([EMAIL PROTECTED])
http://www.denninger.net
Scott Marlowe wrote:
On Sun, Mar 2, 2008 at 1:41 PM, Karl Denninger <[EMAIL PROTECTED]> wrote:
Ugh.
I am attempting to move from 8.2.6 to 8.3, and have run into a major
problem.
The build goes fine, the install goes fine, the pg_dumpall goes fine.
However, the reload does not. I do the initdb and then during the
reload I get thousands of errors, apparently from table data which is
perfectly ok in the tables, but pukes up a hairball when attempted to be
reloaded.
So what error message?
---------------------------(end of broadcast)---------------------------
TIP 1: if posting/reading through Usenet, please send an appropriate
subscribe-nomail command to [EMAIL PROTECTED] so that your
message can get through to the mailing list cleanly
%SPAMBLOCK-SYS: Matched [hub.org+], message ok
