On 07/23/2012 02:23 PM, Adam Crews wrote:
On Mon, Jul 23, 2012 at 8:34 AM, Robert Haas <robertmh...@gmail.com> wrote:
On Sat, Jul 21, 2012 at 1:24 AM, Adam Crews <adam.cr...@gmail.com> wrote:
Hello,
I'm sorry for cross-posting, however I originally posted this to
pgsql-general list, but didnt get any replies.
Then I posted to pgsql-cluster-hackers..., and now here.
I’m using pg 9.1.3 on CentOS 5 and have a few slave databases setup
using the built in streaming replication.
On the slaves I set the “listen_addresses” config option to an ip
address for a virtual alias on my network interfaces. The host has an
address of 10.1.1.10, and there is a virtual alias of 10.1.1.40 that
the slave postmaster binds to.
When the slave makes it connection to the master to start replication
the source address for the connection is the host address, not the
virtual alias address. Connections appear to come from 10.1.1.10,
instead of the slave postmaster address of 10.1.1.40.
This seems like a bug to me. I could understand that if the
postmaster is listening on all interfaces, then it should use whatever
the IP is for the for the host, but in an instance where the
postmaster has been configured to listen to a specific address it
seems like the call to start the replication should be passed that
address so connections come from the slave postmaster’s IP, instead of
the host.
Is there a config option that can be used to adjust this? I've looked
in the docs, but haven't found one yet.
Is this perhaps a bug, or lack of feature?
I don't think it's a bug, because the behavior you're hoping for might
not be what everyone would want in a similar situation. It might
qualify as an unimplemented feature.
This mailing list isn't heavily used and this seems a bit off-topic
for it anyway; you might want to try a different one for further
discussion of this issue.
So, I think this, as Robert states, an unimplemented feature.
For my situation it would be very useful to have an option to be able
to specify the source address for replication.
I discovered this because I bind the listen address for postgres to a
single address even though the host system may have multiple
addresses. I then use that single address in iptables rules on other
systems. Since I expect the slave to be at a .40 address, but the
replication comes from the primary address of the interface (in this
case .10), my iptables rules were missing the access for the slave to
connect to the master.
This site http://linux-ip.net/html/routing-saddr-selection.html
describes the behavior I'm seeing.
How do I go about requesting a config option that would allow me to
specify the source address for the replication connections?
You just have :-)
You could just add an iptables rule redirecting .10 packets on port 5432
(or whatever you're using) appropriately.
We don't have any provision for binding the local end of any connection
AFAIK. So the first question is "Do we want to?" and the second is "If
yes, when and how?" I don't see that replication should be a special
case - if this is worth providing for it should be applicable to all
clients, ISTM.
cheers
andrew
--
Sent via pgsql-hackers mailing list (pgsql-hackers@postgresql.org)
To make changes to your subscription:
http://www.postgresql.org/mailpref/pgsql-hackers
