>Document doesn't say this changes are only for implicit BEGIN.. Correcting myself here. Not just implicit BEGIN, it will throw an error on \set AUTOCOMMIT inside any any transaction provided earlier value of AUTOCOMMIT was OFF. Probably the test in which you tried it was already ON.
Thank you, Rahila Syed On Fri, Sep 2, 2016 at 3:17 PM, Rushabh Lathia <rushabh.lat...@gmail.com> wrote: > > > On Fri, Sep 2, 2016 at 1:12 PM, Rahila Syed <rahilasye...@gmail.com> > wrote: > >> Hello, >> >> Thank you for comments. >> >> >Above test not throwing psql error, as you used strcmp(newval,"ON"). You >> >should use pg_strcasecmp. >> Corrected in the attached. >> >> >Above error coming because in below code block change, you don't have >> check for >> >command (you should check opt0 for AUTOCOMMIT command) >> Corrected in the attached. >> >> >postgres=# BEGIN; >> >BEGIN >> >postgres=# create table foo ( a int ); >> >CREATE TABLE >> >postgres=# \set AUTOCOMMIT ON >> >Don't you think, in above case also we should throw a psql error? >> IMO, in this case BEGIN is explicitly specified by user, so I think it is >> understood that a commit is required for changes to be effective. >> Hence I did not consider this case. >> >> > Document doesn't say this changes are only for implicit BEGIN.. > > + <note> > + <para> > + Autocommit cannot be set on inside a transaction, the ongoing > + transaction has to be ended by entering <command>COMMIT</> or > + <command>ROLLBACK</> before setting autocommit on. > + </para> > + </note> > > In my opinion, its good to be consistent, whether its implicit or > explicitly specified BEGIN. > > >postgres=# \set AUTOCOMMIT off >> >postgres=# create table foo ( a int ); >> >CREATE TABLE >> >postgres=# \set XYZ ON >> >\set: Cannot set XYZ to ON inside a transaction, either COMMIT or >> ROLLBACK and retry >> >> >May be you would like to move the new code block inside SetVariable(). >> So that >> >don't need to worry about the validity of the variable names. >> >> I think validating variable names wont be required if we throw error only >> if command is \set AUTOCOMMIT. >> Validation can happen later as in the existing code. >> >> > It might happen that SetVariable() can be called from other places in > future, > so its good to have all the set variable related checks inside > SetVariable(). > > Also you can modify the condition in such way, so that we don't often end > up > calling PQtransactionStatus() even though its not require. > > Example: > > if (!strcmp(opt0,"AUTOCOMMIT") && > !strcasecmp(newval,"ON") && > !pset.autocommit && > PQtransactionStatus(pset.db) == PQTRANS_INTRANS) > > > >Basically if I understand correctly, if we are within transaction and >> someone >> >tries the set the AUTOCOMMIT ON, it should throw a psql error. Correct me >> >if I am missing anything? >> >> Yes the psql_error is thrown when AUTOCOMMIT is turned on inside a >> transaction. But only when there is an implicit BEGIN as in following case, >> >> postgres=# \set AUTOCOMMIT OFF >> postgres=# create table test(i int); >> CREATE TABLE >> postgres=# \set AUTOCOMMIT ON >> \set: Cannot set AUTOCOMMIT to ON inside a transaction, either COMMIT or >> ROLLBACK and retry >> postgres=# >> >> Thank you, >> Rahila Syed >> >> > > > Regards, > Rushabh Lathia > www.EnterpriseDB.com >