Simon Riggs <[EMAIL PROTECTED]> writes:
>> It does nothing AFAICS for the
>> problem that when restarting archive recovery from a restartpoint,
>> it's not clear when it is safe to start letting in backends. You need
>> to get past the highest LSN that has made it out to disk, and there is
>> no good way to know what that is.
> AFAICS when we set minRecoveryLoc we *never* unset it. It's recorded in
> the controlfile, so whenever we restart we can see that it has been set
> previously and now we are beyond it.
> So if we crash during recovery and
> then restart *after* we reached minRecoveryLoc then we resume in safe
> mode almost immediately.
What minRecoveryLoc is is an upper bound for the LSNs that might be
on-disk in the filesystem backup that an archive recovery starts from.
(Defined as such, it never changes during a restartpoint crash/restart.)
Once you pass that, the on-disk state as modified by any dirty buffers
inside the recovery process represents a consistent database state.
However, the on-disk state alone is not guaranteed consistent. As you
flush some (not all) of your shared buffers you enter other
not-certainly-consistent on-disk states. If we crash in such a state,
we know how to use the last restartpoint plus WAL replay to recover to
another state in which disk + dirty buffers are consistent. However,
we reach such a state only when we have read WAL to beyond the highest
LSN that has reached disk --- and in recovery mode there is no clean
way to determine what that was.
Perhaps a solution is to make XLogFLush not be a no-op in recovery mode,
but have it scribble a highest-LSN somewhere on stable storage (maybe
scribble on pg_control itself, or maybe better someplace else). I'm
not totally sure about that. But I am sure that doing nothing will
regards, tom lane
Sent via pgsql-patches mailing list (firstname.lastname@example.org)
To make changes to your subscription: