Hi Tom,
Is there any way to work out what plan the query is using in side the
function? I think I have a similar problem with a query taking much
longer from inside a function than it does as a select statement.
Regards
Matthew
Tom Lane wrote:
Claire McLister <[EMAIL PROTECTED]> writes:
When I do an EXPLAIN ANALYZE on one query that returns 3261 rows, it
executes in a reasonable 159ms:
...
If I issue the same query over JDBC or use a PSQL stored procedure, it
takes over 3000 ms, which, of course is unacceptable!
I suspect that the problem is with "groupid = $1" instead of
"groupid = 57925". The planner is probably avoiding an indexscan
in the parameterized case because it's guessing the actual value will
match so many rows as to make a seqscan faster. Is the distribution
of groupid highly skewed? You might get better results if you increase
the statistics target for that column.
Switching to something newer than 7.4.x might help too. 8.1 and up
support "bitmap" indexscans which work much better for large numbers
of hits, and correspondingly the planner will use one in cases where
it wouldn't use a plain indexscan.
regards, tom lane
---------------------------(end of broadcast)---------------------------
TIP 1: if posting/reading through Usenet, please send an appropriate
subscribe-nomail command to [EMAIL PROTECTED] so that your
message can get through to the mailing list cleanly
_____________________________________________________________________
This e-mail has been scanned for viruses by Verizon Business Internet Managed
Scanning Services - powered by MessageLabs. For further information visit
http://www.verizonbusiness.com/uk
