Hi Luis, Ondrej,
On Wed, Apr 03, 2024 at 09:03:52AM -0600, g...@luigi311.com wrote:
> From: Luis Garcia <g...@luigi311.com>
>
> On some boards powerdown signal needs to be deasserted for this
> sensor to be enabled.
>
> Signed-off-by: Ondrej Jirman <m...@xff.cz>
> Signed-off-by: Luis Garcia <g...@luigi311.com>
> ---
> drivers/media/i2c/imx258.c | 13 +++++++++++++
> 1 file changed, 13 insertions(+)
>
> diff --git a/drivers/media/i2c/imx258.c b/drivers/media/i2c/imx258.c
> index 30352c33f63c..163f04f6f954 100644
> --- a/drivers/media/i2c/imx258.c
> +++ b/drivers/media/i2c/imx258.c
> @@ -679,6 +679,8 @@ struct imx258 {
> unsigned int lane_mode_idx;
> unsigned int csi2_flags;
>
> + struct gpio_desc *powerdown_gpio;
> +
> /*
> * Mutex for serialized access:
> * Protect sensor module set pad format and start/stop streaming safely.
> @@ -1213,6 +1215,8 @@ static int imx258_power_on(struct device *dev)
> struct imx258 *imx258 = to_imx258(sd);
> int ret;
>
> + gpiod_set_value_cansleep(imx258->powerdown_gpio, 0);
What does the spec say? Should this really happen before switching on the
supplies below?
> +
> ret = regulator_bulk_enable(IMX258_NUM_SUPPLIES,
> imx258->supplies);
> if (ret) {
> @@ -1224,6 +1228,7 @@ static int imx258_power_on(struct device *dev)
> ret = clk_prepare_enable(imx258->clk);
> if (ret) {
> dev_err(dev, "failed to enable clock\n");
> + gpiod_set_value_cansleep(imx258->powerdown_gpio, 1);
> regulator_bulk_disable(IMX258_NUM_SUPPLIES, imx258->supplies);
> }
>
> @@ -1238,6 +1243,8 @@ static int imx258_power_off(struct device *dev)
> clk_disable_unprepare(imx258->clk);
> regulator_bulk_disable(IMX258_NUM_SUPPLIES, imx258->supplies);
>
> + gpiod_set_value_cansleep(imx258->powerdown_gpio, 1);
> +
> return 0;
> }
>
> @@ -1541,6 +1548,12 @@ static int imx258_probe(struct i2c_client *client)
> if (!imx258->variant_cfg)
> imx258->variant_cfg = &imx258_cfg;
>
> + /* request optional power down pin */
> + imx258->powerdown_gpio = devm_gpiod_get_optional(&client->dev,
> "powerdown",
> + GPIOD_OUT_HIGH);
> + if (IS_ERR(imx258->powerdown_gpio))
> + return PTR_ERR(imx258->powerdown_gpio);
> +
> /* Initialize subdev */
> v4l2_i2c_subdev_init(&imx258->sd, client, &imx258_subdev_ops);
>
--
Regards,
Sakari Ailus
