I looked at that last night and it seems to be ok. I used a couple drops of light sewing machine oil at each end and where the governor moves back and forth. Also made sure there was very little play back and forth of the center shaft in the governor. I plan on taking it back to him when he finishes putting another spring in my Victor I. But I thought I could try something easy that might work instead of hauling it back over to him. Thanks, keith
-----Original Message----- From: Loran T. Hughes [mailto:[email protected]] Sent: Friday, April 16, 2004 1:17 PM To: Antique Phonograph List Subject: Re: [Phono-L] My Victor V Keith, My guess would be that the governor needs adjustment. It may be binding in the end bearings. The governor should have a small amount of play. Also, make sure the bearings are lubricated with a drop of light (sewing machine type) oil. Loran On Fri, 2004-04-16 at 04:59, Carter, Keith wrote: > Hello All, > I told everyone about my Victor V Find for about $1000.00 about 1 ? months > ago and wanted to know about restoring and repairing the motor and Oak Spear > Tip horn. > Well, I had the horn restored and looks GREAT. REALLY GREAT. > I also had the motor redone. Before I could only get about 60 cranks and > then you could hear the spring unwind. Someone told me on the list that the > springs in the back might be broke. > Here is what it was. > The guy that fixed the motor said the last two springs were unhooked. > SOOOOOOO: > I now have a problem with the motor after I got it back from repair, (WHICH > IS WHY I AM WRITING TO EVERYONE ON THE LIST FOR HELP) : > Sometimes with a full crank the turntable won't even start to turn. > OR, when I crank the motor up the record slows down then speeds up. It won't > keep an even speed. > > When I only had use of one spring before I took it in for repair, I could at > least play 3 sides of records before winding it up again. NOW with the > springs fixed, I am lucky to get 1 side to play. I have to help the > turntable to get started. The record starts to play then you hear it slow > down then speed back up again. Does this several times just playing one > side. > I also hear some small noise (nothing hitting that I can tell) inside. I > don't see where the governor is hitting anything. That seems to be okay. > MAYBE THE PROBLEM: > Could the guy that repaired the motor put too much grease in the casing? > Should he have replaced the springs with heavier ones? > > Can use your help. > Thanks, > Keith Carter _______________________________________________ Phono-l mailing list [email protected] http://t2.cwihosting.com/mailman/listinfo/phono-l_oldcrank.com From mike Fri Apr 16 13:38:31 2004 From: mike (Mike Stitt) Date: Sun Dec 24 13:10:38 2006 Subject: [Phono-L] My Victor V References: <[email protected]> Message-ID: <000b01c423e2$0bf98720$da301...@customer5hyqv0> Kieth, Make sure that the ball bearing is still below the spindle shaft. You may want to look at the spindle gear. They seem to "run better" if the gear is above or below the governor shaft "spiral" center line.Check for binding barrels Mike aka oldcranky It is not a spur motor right? ----- Original Message ----- From: "Carter, Keith" <[email protected]> To: "'Antique Phonograph List'" <[email protected]> Sent: Friday, April 16, 2004 10:24 AM Subject: RE: [Phono-L] My Victor V I looked at that last night and it seems to be ok. I used a couple drops of light sewing machine oil at each end and where the governor moves back and forth. Also made sure there was very little play back and forth of the center shaft in the governor.
