Just wondering whether the Saturday Night discussion forum on Phono-L will be up and running again at some point. Many of us enjoy this Saturday Night Phono Chat, and are of course hoping that it will be back in action soon. Thanks Loran!!
Bruce From [email protected] Sat Mar 19 19:26:14 2005 From: [email protected] (bruce78rpm) Date: Sun Dec 24 13:10:16 2006 Subject: [Phono-L] Phonograph Forum is again up and running Message-ID: <000901c52cfc$929b7710$6401a...@custom> Contact has been restored. Thanks Loran!! From [email protected] Sun Mar 20 15:18:54 2005 From: [email protected] (Daniel Melvin) Date: Sun Dec 24 13:10:16 2006 Subject: [Phono-L] Early L-door motor board question Message-ID: <001a01c52da3$33cdc650$6501a...@danslaptop> I have a very nice early L-door Victrola XVI that was missing the motor board and motor. I had everything else. It takes the VTLA style motor board which sits on top instead of being inset. I found a motor board and motor and it fits perfectly down to the screw holes except for one problem. The crank shaft on the motor sits about 1/4 too high for the crank. It's in exactly the right place, just a bit high. Does anyone know if there are thinner motor boards for this type of machine? The only other machine I have with top mounted motor boards is a Victrola XII which has a thinner and slightly different setup than a XVI. Any suggestions or ideas out there? Thanks Dan From [email protected] Sun Mar 20 18:40:46 2005 From: [email protected] (Ron L'Herault) Date: Sun Dec 24 13:10:16 2006 Subject: [Phono-L] Early L-door motor board question In-Reply-To: <001a01c52da3$33cdc650$6501a...@danslaptop> Message-ID: <00ba01c52dbf$6622d750$1b5ed...@ronlherault> How is the height of the turn table to the motor board? Maybe someone left off the washers (felt or rubber, I'm not sure) that were probably between motor and board. Ron L -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Daniel Melvin Sent: Sunday, March 20, 2005 6:19 PM To: [email protected] Subject: [Phono-L] Early L-door motor board question I have a very nice early L-door Victrola XVI that was missing the motor board and motor. I had everything else. It takes the VTLA style motor board which sits on top instead of being inset. I found a motor board and motor and it fits perfectly down to the screw holes except for one problem. The crank shaft on the motor sits about 1/4 too high for the crank. It's in exactly the right place, just a bit high. Does anyone know if there are thinner motor boards for this type of machine? The only other machine I have with top mounted motor boards is a Victrola XII which has a thinner and slightly different setup than a XVI. Any suggestions or ideas out there? Thanks Dan _______________________________________________ Phono-L mailing list [email protected] Phono-L Archive http://www.oldcrank.org/pipermail/phono-l/
