> As you correctly guessed I am trying to get a Palm m500 to sync.
<lots snipped>, please don't quote the entire message unless it's relevant =)
Ok, as am I. This does not currently work, at all yet.
You will get as far as a connect, but that's it. I was able to get it
connected to my box, and seen, but nothing magical will happen at that point.
I don't know enough about USB to figure this one out. Greg?
Here's what I get on my box:
kernel: hub.c: USB new device connect on bus1/1, assigned device number 5
kernel: usbserial.c: Palm M505 converter detected
visor.c: visor_startup
visor.c: visor_startup - Set config to 1
visor.c: visor_startup - length = 20, data = 01 00 00 00 63 6e 79 73 02 00 00
00 01 4e 00 5c 00 00 00 09
visor.c: visor_startup - length = 20, data = 01 00 00 00 63 6e 79 73 02 00 00
00 01 4e 00 5c 00 00 00 09
usbserial.c: Palm M505 converter now attached to ttyUSB0 (or usb/tts/0 for
devfs)
usbserial.c: Palm M505 converter now attached to ttyUSB1 (or usb/tts/1 for
devfs)
visor.c: visor_open - port 1
visor.c: visor_ioctl - port 1, cmd 0x5401
visor.c: visor_ioctl - port 1, cmd 0x5401
visor.c: visor_ioctl - port 1, cmd 0x5402
visor.c: visor_set_termios - port 1
visor.c: visor_set_termios - nothing to change...
visor.c: visor_read_bulk_callback - port 1
visor.c: visor_read_bulk_callback - length = 22, data = 90 01 00 00 00 00 00
00 00 20 00 00 00 08 00 00 01 00 00 00 00 00
visor.c: visor_ioctl - port 1, cmd 0x5401
visor.c: visor_ioctl - port 1, cmd 0x5401
visor.c: visor_ioctl - port 1, cmd 0x5403
visor.c: visor_chars_in_buffer - port 1
visor.c: visor_chars_in_buffer - returns 0
visor.c: visor_set_termios - port 1
visor.c: visor_set_termios - nothing to change...
visor.c: visor_chars_in_buffer - port 1
visor.c: visor_chars_in_buffer - returns 0
/d
_______________________________________________
Pilot-unix mailing list
[EMAIL PROTECTED]
http://hcirisc.cs.binghamton.edu/mailman/listinfo/pilot-unix
